How to Paint a Pinewood Derby Car to Give It a Glossy Finish
Sandpaper and paint can turn a block of wood into a sleek Pinewood Derby racer that looks as smooth as steel. The trick is using the right materials and allowing plenty of time.
Don’t wait until the last minute! For best results, you’ll need to start at least a week or two before the race. You’ll also need help from a trusted adult.
WHAT YOU’LL NEED TO PAINT A PINEWOOD DERBY CAR
- Coarse, medium and fine-grit sandpaper
- Liquid sanding sealer (sold at hobby shops)
- Enamel paint
- Decals or self-stick numbers (sold at stationery stores or hobby shops)
- Clear gloss paint
- Floor wax paste
WHAT YOU’LL DO TO PAINT A PINEWOOD DERBY CAR
Step 1: Begin by wrapping sandpaper around a block of wood 1 inch by 3 inches. Without a block of wood for support, sandpaper can leave dips and gullies in the Pinewood Derby car’s body.
Round the corners of the pinewood block with coarse sandpaper. Change to medium-grit paper for smoothing rough edges. Finish with fine sandpaper to remove any sanding marks.
Step 2: Just painting the pinewood won’t hide the wood’s grain. Apply two coats of liquid sanding sealer. Let the sealer dry overnight before sanding it lightly with fine-grit paper.
If the grain still shows, apply two more coats of sealer. Let it dry overnight and sand again. Repeat the process until the grain disappears.
Step 3: Choose a color for your Pinewood Derby car. Then apply two to three coats of enamel paint to the car’s body. Spraying the model with paint from an aerosol can is easier than using a brush.
If you use a brush, dip only the lower third of the brush into the paint. Use single, smooth strokes instead of dabbing the paint on the car. Blend the strokes so they can’t be seen.
Step 4: Place a race number on the Pinewood Derby car. Seal and protect it by spraying the entire car with clear gloss paint. Some clear paints might make the numbers curl. To make sure yours works, test it on a decal or number stuck to scrap plastic before spraying your car.
Step 5: Let the clear paint dry for at least a week. Then cover the Pinewood Derby car with floor wax paste and polish to a high gloss. The wax will protect the car and help give your racer the look of shining steel.
JUST DO YOUR BEST
This project requires help from an adult and lots of time and patience.
Instead, you can always just paint your Pinewood Derby car with one layer of paint from your local hobby store. It takes only a few minutes, and it still looks great.
The important thing is to have fun and do your best.
great idea
I value the advice. Thanks alot.
After the first smooth sanding, wipe the block with a damp cloth to raise the grain and then sand again.
A smoother finish may be had by sanding in the direction of the wood’s grain, instead of against the grain.
how can i make my car faster
Good point about sanding with the grain. I think that a lot of people would assume that people already know this, but depending on how much woodworking someone has had, they might not. I learned it myself when I was 11 in Orioles. But no one ever told my husband. If I hadn’t known then our boys wouldn’t have known. It’s like cutting meat “across the grain” to make more tender cuts of meat. It seems obvious, but unless you’ve been told then you don’t know it.
good idea.
Any advice is nice! Thanks,
i can use this in a lot of ways my awana car and for fun
me likey
everybody knows these steps! even boys that are my age know this! >:(
not everyone knows them I just learned the steps
I am a great grandma and helping my grandson…so my dear..not everyone knows these steps…Thank You.
i not like it
i ugree
282439